| |
|
|
|
|
|
|
|
|
|
|
 |
|
Materials: |
|
|
|
|
Li'l Hands Construction board
Li'l Hands Coloring Pens
Li'l Hands Craft Scissors
T Pencil
yarn
punch hole |
|
|
Steps: |
|
|
|
|
|
|
|
|
|
|
|
- Use Amspec scissors to cut Li'l Hands Construction board in half widthwise.
- Use the hole punch to punch 9 holes about ½" apart down each of the shorter sides. Punch 6 along one long side about ½" from edge, and 2 on the remaining side.
- Cut out and press star shapes onto Li'l Hands Construction board. Apply glue at the back of each stars then press in place on windsock where desired.
- Add swirls and dots from each star using Li'l Hands Coloring Pens.
- To connect the edges together, Roll the construction board length-wise to form a tube. Glue or attach both ends together.
- Cut two 30" pieces of yarn. Fold in half. Line the edges of the two pieces overlapping at holes. Insert one end of yarn through both holes and continue lacing up side.
- Insert other end of lacing from opposite side and continue lacing up same side, filling in areas between holes, refer to photo for placement. Repeat step with other side, creating the windsock. Trim ends to about an inch.
- Cut four 30" lengths of four different colors of yarn. Thread a single color though each hole then tie a knot with ends.
|
|
|
|
|
|
|
|
|
|
